16 May 2007

Green Register Seminar – Integrated Design

new-islington.jpg

 Case Study – Urban Splash @ New Islington
  

  • 12 Hectare Site 
  • Part of Millenium Housing Sites 
  • 1970’s Housing Estate dubbed the Worst Estate in Manchester 
  • Assests retatined – 
    • Canal Network 
    • Community Spirit 
  • Collaborative Workshops offered re-housing options to residents 
  • Rebranding of estate 
  • Will Alsop Masterplan, including “the Chips” 
  • Mixed Use, including 
  • 1700 new homes 
  • Variety of Parks – Community Park, Wildlife Island, Orchard, Boardwalk, Beach 
  • Revival of Waterway 
  • Primary School 
  • Primary Care Centre 
  • Small Scale Retail 
  • 180units/hectare 
  • All dwellings to achieve Eco-Homes Excellent 
  • Maximise use of natural sunlight 
  • Use of low embodied energy materials throughout 
  • Combined Heat and Power, future-proofed for bio-fuels 
  • Jobs created for local people within the construction phase
      

Things you might forget, or things you might not know… 

 

  • Integrate design at an early stage – ideally stage A/B, rather than at Stage C/D – consulting Energy Engineers / assessors. Check for Policy changes if the project has been on hold for a while.
      
  • Recent UK Policy changes include PPS1 Addendum –
                Demonstrate how building regulations to be met at planning stage
      
  • Passive Design – 
    • Use the sun’s energy to reduce winter heating requirement 
    • Orientate main façade within 30degrees of south 
    • Avoid overshadowing 
    • Utilise thermal mass to store heat 
    • Minimise glazing to north façade 
    • Add a glazed winter garden to south façade 
    • Incorporating 2-3% Carbon Dioxide emission savings may reduce the “renewables” target – spray taps, smaller baths, energy efficient applicances + lights
  • Remember to design in CHP Spaces into 1st phase of phased construction
    Use Thermal Analysis at scheme design stage to highlight potential overheating + design out prior to planning consent
      
  • Check Planning Policy for correct wording –
    If 10% CO2 saving is required, target electrical – 3.5m2 Solar Thermal panels should achieve target saving
    If 10% Energy saving is required, target Gas – 2.2m2 Solar Thermal panels should achieve target saving
      
  • Code for Sustainable Homes – Water
    Average UK use – 150 litres/person/day
    Typical Spec – 190 l/p/d
                6l Standard WC
                full flow taps
                standard bath – 200l
                shower – 15 l/minute flow
    Level 3 – 105 l/p/d
                Dual Flush 6/4 l WC
                Aerated taps
                Small bath – 150l
                6 litre shower 

Level 5 – 80 l/p/d 

Dual Flush 4/2 l WC 

Aerated taps 

Small bath 

Less than 6litre shower

Rainwater / Greywater harvesting for WC Flush 

 Products
   

  • Pilkington “Optitherm” glazing controls heat loss and solar gain  
  • “Ecoplay” grey water systems will treat + recycle grey water for use in WCs  
  • “Dupont Energain” is a gypsum/paraffin Wax sealed board, which absorbs heat in lightweight construction by altering its state (effectively melts and solidifies) in hot temperatures. More info    
  • Wind Turbines –  
    • Swift (1.5kW, 2.1m diameter), £5250, provides approx 50% electricity needs of a 3bed house  
    • Proven (15kW, 9m diameter), £40,000, provides all electricity needs of 7.5no. 3bed houses      

 

 

1 Comment

  1. 16 May 2007 @ 1:12 pm Chris Potter said:

    Very interesting. The New Islington website needs some patience, or am I getting old? Can we educate our M&E colleagues?

Post a comment

You must be logged in to post a comment.